7 • Disassembly, Cleaning and Disinfection
50 / 66
80110-801_V23493
2022-03
Instructions for cleaning and disinfection
1. Mix the disinfectant in the concentration specified by the manufacturer.
2. Clean any visible contamination before disinfecting (e.g. blood) from the surfaces
using the disinfectant. Otherwise the efficacy of the subsequent disinfection may
be impaired.
3. Carry out a visual inspection after cleaning. If you find any residual contamination,
repeat cleaning until all contamination has been removed.
4. Carry out wipe disinfection. Make sure the surfaces are treated uniformly. Observe
the information provided by the manufacturer regarding the prescribed reaction
time.
What should you do if it is not
possible to carry out a full clean?
Note: If it is not possible to carry out a full clean, do not carry out a wipe disinfection.
Do not use the unit. Contact Technical Service.
To Next Page
Loading...
