Ericsson AVP 2000 Series - Checking the Bit Rates of the Different Components in a Transport Stream

Web GUI Control
5-14
EN/LZT 790 0023/1 R16A
1. In the Outputs widget, select the Transport Stream, service or component
whose parameters you want to access.
2. Right click on the selected item, and choose Edit Properties from the context
menu.
3. The view will change to the Service Configuration page with the item selected
in the Outputs widget.
The Setmode state is reflected how the Transport Streams are color coded in the
Transport Stream Rates accordion panel of the Bit Rate Utilization widget. The
color codes are shown in Table 5.1.
Table 5.1 Setmode State Color Codes
State Color
Online green
Offline grey
Preview light green
Retire orange
5.2.2.2 Checking the Bit Rates of the Different Components in a Transport Stream
To check the bit rates of services and components in a Transport Stream, do the
following:
1. In the Transport Stream Rates accordion panel of the Bit Rate Utilization
widget, click on the Transport Stream whose components you want to check.
2. The bit rates are shown in a table in the Component Bit Rates per Transport
Stream accordion panel. The bit rates of the components are also shown if the
mouse is hovered over a component in the pie chart.
Figure 5.12 Component Bit Rates per Transport Stream Accordion Panel