Ericsson AVP 2000 Series - Setting up BISS from the GUI

Getting Started
EN/LZT 790 0023/1 R16A
3-45
From the front panel it is necessary to enter the key value into the table location by
navigating to Advanced > System > Base Unit > BISS keys table. Use the rotary
knob to scroll to the required BISS Key (1 – 31), select and enter the required key
value.
Note: This does not enable BISS.
3.17.3 Setting Up BISS from the GUI
To set up BISS encryption for a service from the GUI:
1. If you want to use BISS Mode-E, browse to the Device Configuration >
Advanced Setup tab, open the Encode > Base Unit node in the Advanced
Video Processor Settings widget, and add the injected ID in the BISS injected
ID (14 hexadecimal characters) field.
2. If you have not already done so, create a Transport Stream and a service as
described in Section 3.8.3.
3. Go to the Outputs widget of the Service Configuration page, and select the
service for which you want to apply BISS encryption.
4. In the properties tab select the drop down option against BISS Key, which will
show the list of 31 keys. Select the required key location.
Note: If None is selected, BISS will not be enabled.
Figure 3.23 BISS Enabling and Key Selection