Ericsson AVP 2000 Series - Rear Panel Signal Connectors; Signal Connections

Installing the Equipment
2-4
EN/LZT 790 0023/1 R16A
2.3 Signal Connections
2.3.1 Rear Panel Signal Connectors
Caution!
It is strongly recommended that the terminal marked at the rear panel of the
equipment is connected to a site Technical Earth before any external connections
are made and the equipment is powered. This limits the migration of stray charges.
Signal connections are made via the rear panel. The rear panels, which are
available are shown below. Full technical specifications for the connections are
given in Annex B.
Only the Data and Control Ethernet connectors and the PSU connectors are
mounted on the chassis. All other connections at the rear panel are provided with
the option modules that may be fitted. Examples are shown below.
Figure 2.2 Rear Panel With CE-x VCM, SatMod and ASI I/O Options Fitted
Data Ethernet (x4)
Control Ethernet (x2)
SatMod
ASI I/O Module
CE-x VCM