Ericsson AVP 2000 Series - Chapter 3; How to Connect up the Unit; Introduction

Getting Started
EN/LZT 790 0023/1 R16A
3-5
3.1 Introduction
Due to the number of different ways the Advanced Video Processor (AVP) Series
can be used, it is impossible to give precise setting up instructions for every possible
working scenario. This chapter, therefore, gives general guidance and principles on
how to power up and set up your unit for operation and describes the more common
operations you will want to perform.
For details of all Front Panel menus and controls, see Chapter 4, Front Panel
Control. For details of all Web Graphical User Interface (GUI) menus and controls,
see Chapter 5, Web GUI Control.
For more information on possible networking scenarios, see Chapter 6, Advanced
Video Processing and Networking.
3.2 How to Connect Up the Unit
See Chapter 2, Installing the Equipment for all connector details.
Figure 3.1 AVP Connections