Getting Started
Redundancy Mode Description Type of Network
Different Network
• Each interface has different IP configuration.
• This is set using the Physical Interface IP settings for each
Interface.
• The unit automatically assigns the Source Address for each
output TS to be the address configured for the Physical Interface
used for that TS.
Active - Standby Only the primary interface (Data 3) will
transmit the output TS.
If the primary interface goes Link-
Down, the TS is sent from the
secondary interface (Data 4).
Configuration to control auto-revert is
provided).
Same Network
• Both interfaces are configured to be on the same network.
• They have identical IP configuration, which is set using the
Interface Group IP address (Virtual IP Address). The Physical
Interface IP address does not need to be set and can remain at
0.0.0.0.
• The unit automatically assigns the Source Address for output TS
to be the IP address of the Interface Group.
Different Network
• Not supported in Active – Standby mode.
3.8 How to Configure the AVP Using the Web GUI
The unit is configured using the web browser Graphical User Interface (GUI). For
details of all the GUI screens and options, see Chapter 5, Web GUI Control.
For details of supported Web Browsers please refer to the release notes
accompanying the software release.
3.8.1 General AVP Configuration
The configuration consists of two phases. First, the general parameters of the base
unit and the option cards are configured through the Device Configuration web
page. Then, the output streams can be configured through the Service
Configuration web page.
To save any changes made, click on the Apply All button located at the right side of
the user interface below the page tabs.
Note: To save time, save the changes only after each parameter has been
altered. When trying to leave a page without saving the changes, a dialog is
displayed which allows saving or discarding the changes or abandoning the
page.
The modified folders in the Advanced Video Processor Settings widget and the
corresponding parameters in the Properties widget are highlighted in orange.
Moreover, the changes are also listed on the Changes tab of the Information
widget. To undo a change, simply click on it in the Information widget. The
appropriate item shows up in the Properties widget and its original value can be
restored manually.
To Next Page
Loading...