EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
110 (200)
ADSL Example: For ADSL slot 2, enter either 3201, 201, 1201, or 2201
as appropriate in the 1
st
entry in this column, then right click & select the
“copy” option. Left click on the 2
nd
entry & drag down to the bottom of the
column to highlight all the other entries. Right click & select
“Paste/increment/spread”, all entries in the column will now be
incremented by one down to the last entry.
SHDSL Example: If SHDSL slot20 is being fitted, refer to the relevant C-
VLAN table above. Enter either 3777 (for Parent EDA2530) or 777 (for
Child#1 EDA2530) or 1777 (for Child#2 EDA2530) or 2777 (for Child#3) as
appropriate in the 1
st
SHDSL entry in this column, then right click & select
the “copy” option. Left click on the next entry & drag down to the bottom of
the column to highlight all the other entries. Right click & select
“Paste/increment/spread”, all entries in the column will now be
incremented by one down to the last entry.
g. Go back and select the “Control” tab.
h. In the “Command” column, set all entries to “enable”, as follows:-
Double click on the 1
st
entry in this column and select the “enable” option,
select the 1
st
entry, left click & drag down to the bottom of the column to
highlight all entries. Right click & select “Replicate cell”, all entries in the
“Command” column should now be set to “enable”. Check that all entries
have been changed correctly.
i. Select “Apply All Rows” from the bottom LHS of the screen. Then wait
approximately 2 min for all rows to be configured ok.
j. Select the “Read Network” function to store all entries, confirm that the
configuration has been built, an example screen is shown below:-
To Next Page
Loading...