Ericsson EDA 2530 - Create S-Vlans on the Parent to Subtend Child#3 (if Required)

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
94 (200)
p. All 12x new “ethG//1/1/3” entries are now created in order to set up the
paths for In-Band Management, Data, Video, & Speech traffic between the
“Parent” (EDA2530) & subtended Child#2 (EDA2530).
7.7.6 Create S-VLANs on the “Parent” to Subtend Child#3 (If required)
Note: This sub-section is only to be applied to the “Parent” EDA 2530 that is
subtending a “Child#3” (EDA 2530).
To subtend Child#3 (EDA 2530) from GigE Port 4, the on-site engineer needs to add
the User Port Interface Name “ethG//1/1/4” for the following S-VLAN entries in the
table:-
• DATA_INBAND
• VIDEO
• VOIP_GW1
• VOIP_GW2
• VOIP_GW3
• VOIP_GW4
• VOIP_GW5
• VOIP_GW6
• VOIP_GW7
• VOIP_GW8