EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
57 (200)
j. From the resulting window change the IP Address to a value in line with the
above table, also refer to the Network Planner’s guide for the site. Leave
the IP Network Mask address at 255.255.255.0, and select “Apply
Changes” to update the OBM IP address.
k. From the left-hand side options select “LOG OUT” to log out of the EDA
2500 Element Manager and return to the internet browser.
l. Close down the Internet Browser.
m. From the main LCT screen select Maintenance > Equipment reboot.
From the following window click on the “Warm reboot” button, select the
“Reboot” option and “Yes” to continue.
n. The equipment will log out of the LCT and the CP card will reboot.
o. Wait around 5 min before attempting to login again, this time using the new
OBM IP address.
5.6 Software Inventory Check
Check the Software Inventory on each 64 x ADSL2+ card, 64 x POTS/VoIP card
and 32 x SHDSL card. The software in the Common Part card identifies the
software release for the shelf. There is one acceptable release.
This table shows the Software R4.21 GA EC2 for the EDA 2530 cards.
EDA 2530 Software R4.21 GA EC2
Card Type Unit Code Software Code Release Date
CP 2530-IP 02HAT00103ACY CXC 172 4796 R3D R3D02 090529
64 x ADSL2+ 02HAT00162AAD CXC 172 3777 R2B R2B27 090129
64 x POTS/VoIP 02HAT00198AAM CXC 172 4797 R2B R2B30 090129
32 x SHDSL 02HAT00274AAE CXC 172 5103 R1B R1B18 090131
a. Logon to the EDA 2530 again.
b. Right click on the Common Part card in slot 1, select HW/SW Inventory
from the option menu.
c. In the window displayed, check that the Running Bank (Yes) contains the
correct software code and release. This is an example screen.
To Next Page
Loading...