Ericsson EDA 2530 - RS232 Serial Cable Set (151-2502;01)

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
36 (200)
3.4.1 RS232 Serial Cable Set (151-2502/01)
This cable is required for connection of the Common Part unit (CP) RS232 interface
to the PC serial COM port, for initial configuration.
IMPORTANT WARNING: Connect this cable to the PC before connecting the RJ12
connector to the Common Part. You must disconnect the RJ12 connector from the
Common Part before connecting or disconnecting any 9-Way connector to the PC.
The operator must NOT switch ON or switch OFF power to the PC while it is
connected to the Common Part card.
1
6
RJ12
Sub-D 9pin FEMALE
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
Sub-D 9pin FEMALE
SERIAL INTERFACE 1
SERIAL INTERFACE 2
Female
Connector
9-Pin Sub-D
Female
Connector
SERIAL INTERFACE 1
SERIAL INTERFACE 2
9-Pin Sub-D
Insertion Key
1
6
RJ12
5
1
9
6
rear view
Code: 151-2502/01
MONITOR
MAINTENANCE