EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
155 (200)
g. Wait until the Address: shows Slot (as selected), Card Type: ADSLx64,
Line: (as selected) then check the Configuration Profile is set to
ADSL2plus_SLOW_BASIC and that only the three Transmission Mode
Type boxes (as shown in step e) are ticked.
h. Repeat steps (f.) to (g.) for all 64 lines on the 64 x ADSL card.
Note: If you find more than 5 incorrectly configured lines on one card, stop
checking and refer to Section 9.1.2 ‘Configure 64 x ADSL Card for ADSL2+
Configuration Profile’.
i. When all 64 lines have been checked on the 64 x ADSL card click on the
Close button to close the window.
j. Repeat the checks (steps a to i) for each new 64 x ADSL Card.
k. If any incorrectly configured ADSL lines were found, they must be re-
configured as described in Section 9.1.2 ‘Configure 64 x ADSL Card for
ADSL 2 + Profile’.
9.1.2 Configure 64 x ADSL Card for ADSL2 + Configuration Profile
This Section is only required if some ADSL lines are incorrectly configured.
9.1.2.1 Disable all 64 ADSL Lines on the 64 x ADSL Card
The ADSL Lines must be disabled before their profile can be changed.
a. From the LCT main screen select the path;-
Configuration → xDSL Line Activation
b. Set the Slot: box to the ADSL card slot to be re-configured.
c. Select the ~ Disable radio button.
d. Click on the GO button. Wait for all 64 lines to be disabled.
To Next Page
Loading...