Ericsson EDA 2530 - Configure SHDSL Stack Profiles

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
118 (200)
Profile Name Wire Interface Min Line Rate bps Max Line Rate bps
1 2 Wire 192K 5696K
Ultra-Short 2 Wire 192K 5696K
Extra-Short 2 Wire 768K 3072K
Short 2 Wire 768K 2752K
Medium 2 Wire 512K 2048K
Long 2 Wire 256K 1024K
Profile Name Downst
CurrCond
Downst
WorstCase
Upst
CurrCond
Upst
WorstCase
Used SNR
Target
Margins
1 5 5 5 5 CurrCondDown
Ultra-Short 5 5 5 5 CurrCondDown
Extra-Short 5 5 5 5 CurrCondDown
Short 5 5 5 5 CurrCondDown
Medium 5 5 5 5 CurrCondDown
Long 5 5 5 5 CurrCondDown
The above tables show a typical example of SHDSL Line Profiles. Actual required
SHDSL Line profiles should be supplied by the Customer.
7.16 Configure SHDSL Stack Profiles
Note: This section ONLY applies to SHDSL Profiles.
Configure the EDA2530 SHDSL Stack Profiles via the LCT.
a. From the LCT main screen select the path Configuration > SHDSL
Profiles and Setup. Click Stack Profiles button. The “SHDSL Stack
Profiles” screen will be displayed:-
Note: If there is an SHDSL card already configured in the EDA2530 then
click the Read Network button to view and check the SHDSL Stack
Profiles. If the profiles are correct this sub-section is not required. If the
profiles are not correct then perform the rest of this sub-section.
b. Select File > Open, then navigate to the “SHDSL Stack Profiles.psp”
template file. Then select Open to load this profiles file.