Ericsson EDA 2530 - Page 117

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
117 (200)
Change the 1
st
entry in this column to the correct IP address, select the 1
st
entry, then left-click the 1
st
entry & drag down to the bottom of the column
to highlight all entries. Right click & select “Replicate cell”, all entries in the
“Ne Name” column will now be set to the required OOB IP Address.
d. In the “Command” column, in the 1
st
entry double click the empty field and
select the “create” option from the drop-down list. Select the 1
st
entry, left
click & drag down to the bottom of the column to highlight all entries. Right
click & select “Replicate cell”, all entries in the “Command” column will
now be set to “create”.
e. Select the Apply Selection button.
f. Select “Read Network”, now wait and be patient whilst the fields in the
table are slowly filled in, refer to the following example screen.
g. Wait until all the entries are stored, when the “Stored Entries” are shown
black all entries have been read.