EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
158 (200)
Lines 1 to 64 will all be selected.
l. Click on the Apply to Selection button.
m. Wait until the ‘Applying the configuration to the selected lines, please wait.’
message disappears.
n. Click on the first ADSL Line configured.
o. Wait until the Address: shows Slot (as selected), Card Type: ADSLx64,
Line: (as selected) then check that the Configuration Profile is set to
ADSL2plus_SLOW_BASIC and the three Transmission Mode Type boxes
(as shown in step i) are ticked.
p. Click on the next ADSL Line to be checked.
q. Repeat steps (o.) to (p.) for all 64 lines on the 64 x ADSL card.
r. When all 64 lines have been checked on the 64 x ADSL card click on the
Close button to close the window.
To Next Page
Loading...