Ericsson EDA 2530 - Page 160

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
160 (200)
9.1.2.4 Enable or Disable an ADSL Line Manually
This Section is only required if an ADSL line needs to be manually Enabled or
Disabled.
a. Place the cursor on the <64 x ADSL unit > to be configured.
b. Right click on the unit and select Lines from the menu.
c. When the ADSL x 64 Lines window appears click on the ADSL Line to be
enabled or disabled then left click on the Configure button.
d. Click on the Status tab.
e. If the Disable button is greyed out, this indicates that the line is disabled.
f. Click on the Enable button to enable the line.
g. The Enable button should now be greyed out and the Disable button should
be available.
h. If the Enable button is greyed out, this indicates that the line is enabled.
i. Click on the Disable button to disable the line.
j. The Disable button should now be greyed out and the Enable button should
be available.