Ericsson EDA 2530

To Next Page

To Previous Page

EDA 2530 Commissioning Procedure for Cable and Wireless Access

1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01

Commercial in confidence

82 (200)

c. For all ADSL cards installed, all the even numbered “intLag” interfaces

need to be selected in the table. This is done by holding down the “ctrl”

key, then click on all even numbered “intlag” interface entries in turn until all

ADSL card entries have been highlighted, ie:-

“intLag//1/2” for slot 2 ADSL card

“intLag//1/4” for slot 4 ADSL card

d. Click on the “Accept selected entries” button, the display will revert back

to the previous screen.

For all of the ADSL cards, the “intLag” interfaces will now be built into the

DATA_INBAND VLAN, as shown in the following screen.

Ericsson EDA 2530 - Page 82