EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
84 (200)
b. In the “VLAN Egress Ports – entry 2” window select “Read NE”.
c. For each SHDSL card(s) the relevant SHDSL slot numbered “intLag”
entries need to be selected in the table. This is done by holding down the
“ctrl” key, then click on each new SHDSL slot numbered “intLag” interface
entry in turn until all new SHDSL card entries have been highlighted, ie
“intLag//1/20” for slot 20 SHDSL card
“intLag//1/21” for slot 21 SHDSL card
“intLag//1/18” for slot 18 SHDSL card
“intLag//1/19” for slot 19 SHDSL card
To Next Page
Loading...