Escient FireBall E-120 - Setup Diagrams - Single FireBall on a Network

PAGE 196
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX G - HOME NETWORKING
Setup Diagrams - Single FireBall on a Network
If you have a single FireBall, attaching a FireBall to your home network is strictly
done for the purpose of sharing access to the internet through one connection: a dial up,
an HPNA network, or an Ethernet connection. Diagrams for each of these scenarios
follows:
2
This manual provides basic setup
diagrams for integrating FireBalls
into a home network.
For additional congurations
or advanced setups, please
check the Escient website at
www.escient.com.
NOTE: Plug your FireBall directly into a wall mounted telephone outlet. Do not use a
phone line splitter because it may cause connection problems.