Escient FireBall E-120 - Changing Volume Lock

PAGE 211
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX H - REMOTE CONTROL
Changing Volume Lock
The Remote is set to control volume of a component through your TV while in the TV,
VCR, Cable, or Satellite mode. However, in an Audio mode (i.e. RCV/TNR; AMP, CD),
you have separate control of your audio component’s volume.
If your TV is not remote controllable, or if you want volume to be controlled by a
different component, you can change the Volume Lock setting to control a volume
through a non-associated mode (e.g., through the cable in the TV mode).
To change Volume Lock to another mode:
1. On the Remote, press and hold CODE SET until the LED blinks twice, then release
CODE SET .
2. Enter 9 - 9 - 3 and then press any mode key once (except TV). The LED will blink
twice.
3. Now, whenever you press VOL +, VOL –,or MUTE, volume will be controlled by
your mode choice.
To change Volume Lock back to the TV mode:
1. On the Remote, press and hold CODE SET until the LED blinks twice, then release
CODE SET .
2. Enter 9 - 9 - 3 and then press TV. The LED will blink twice.
3. Now, whenever you press VOL +, VOL –, or MUTE on the Remote, volume will be
controlled by your TV.