Escient FireBall E-120 - Checking the Codes

PAGE 208
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX H - REMOTE CONTROL
substitute the appropriate key (i.e., AUX, CBL, DVD, RCV) for the (Auxiliary, VCR,
Cable, Satellite, CD, Amplier, or Tuner) component you are searching for.
Checking the Codes
If you have set up the Remote using the Searching For Your Code procedure, you may
need to nd out which four-digit code is operating your equipment.
For example, to nd out which code is operating your TV:
1. On the Remote, press TV once.
2. Press and hold CODE SET until the LED blinks twice, then release CODE SET .
3. Enter 9 - 9 - 0. The LED will blink twice.
4. To view the code for the rst digit, press 1 once. Wait 3 seconds, count the LED
blinks (e.g., 3 blinks = 3) NOTE: If a code digit is “0”, the LED will not blink.
5. Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3 for
the third digit, and 4 for the fourth digit.
6. To check for the codes of your other components, repeat steps 1 through 5, but
substitute the appropriate key (i.e., AUX, CBL, DVD, RCV) component you are
checking. As before, write down each four-digit code.