Estun E-Series - Appendix B Parameters Lists

E300 Operation Manual
Parameters Lists
Document Version: V1.01
ESTUN AUTOMATION Proprietary
II
Appendix B Parameters Lists
The double asterisk (**) at the front of the parameter indicates
this parameter is displayed when you have updated the function.
Constant
Language
Default
中文
Range
中文; English
Unit
－
Description
Select a desired language for the pages.
Unit
Default
mm
Range
mm; Inch
Unit
－
Description
Select a desired length scale for the dimensions.
E300 can convert
the current dimensions automatically when you change this
parameter.
Count Mode
Default
Cnt up
Range
Cnt up; Cnt Down
Unit
－
Description
Select a desired stock count mode.
 To select Cnt Up, the stock counter in production
mode is increased by 1
after each product cycle.
 To select Cnt Down, the stock counter in production mode is decrease
d by
1 after each product cycle. When the counter ha
s reached 0, the control is
stopped.
Down counting can be useful if a pre-
planned quota must be produced. Up
counting could be used to give a report on production progress.
Wait Retract
Default
Yes
Range
Yes; No
Unit
－
Description
In the case of a retract, let the Y-axis wait until the retract is finished.
 To select Yes, when the Y-axis reaches the clamping point, the Y-
axis is
stopped and the retract is started. When the retract is completed, the Y-
axis
moves on.
 To select No, the retract is started when the Y-
axis passes the clamping
point, the Y-axis does not stop.