Estun E-Series - Page 36

E300 Operation Manual
Parameters Lists
Document Version: V1.01
ESTUN AUTOMATION Proprietary
III
System Time
Default
－
Range
－
Unit
－
Description
Set to a proper time for the system. The format is yyyy/MM/dd HH:mm:ss.
For example, 2015/11/23 14:51:00.
Decompression
Time
Default
0.20
Range
0.00 to 99.99
Unit
s
Description
Set the duration
for the decompression process. This parameter affects the
time for tuning ON the valve of Decmp.
Set Change Time
Default
0
Range
0.00 to 9.99
Unit
s
Description
Set a waiting time for entering next step when the previous step is completed.
**
Intermediate R
Default
5
Range
0.00 to 99.99
Unit
mm
Description
Temporary position for the R-
axis, to avoid collision as a result of movement of
the X-axis.
The value 0 disables this functionality. When programmed not equal to zero this
position will be active when the X-
axis has to move inside the safety zone of the
die.
The sequence will be as follows:
a. The R-axis is moved to the intermediate position;
b. then the X-axis is moved to its intended position;
c. finally the R-axis is moved to its intended position.
New Position
Old Position
Intermediate R
for X-movement
X-movement
Material Table
ID
Default
－
Range
1 to 6
Unit
－
Description
The number of the material, which shall be set on the programming page.
MatName
Default
－
Range
Steel; Aluminum; Zn; Stainless Steel; Material5; Material6
Unit
－
Description
The name of the material, which is unable to set.