Estun pronet series - Page 169

ProNet Series AC Servo User's Manual
- 167 -
Parameter
No.
Name Unit
Setting
Range
Factory
Setting
Setting
Invalidation
Pn514
Input port filter 0.2ms 0~1000 1 Immediately
Pn515
Alarm port filter 0.2ms 0~3 1 Immediately
Pn516
Input port signal inversion — 0~1111 0 Immediately
Pn517
Input port signal inversion — 0~1111 0 Immediately
Pn518
Dynamic brake time 0.5ms 50~2000 125 Immediately
Pn519
Serial encoder error time 0.1ms 0~10000 3 Immediately
Pn520
Position complete time 0.1ms 0~60000 500 Immediately
Pn521
If connect externally regenerative resistor
0：connect externally regenerative resistor
between B1 and B2
1：dose not connect externally
regenerative resistor, relay on internal
capacitance
（This parameter is in effect only on
ProNet-02/04
/ProNet-E-02/04）
— 0~1 1 Immediately
Pn522
Reserved — — — —
Pn523
Reserved — — — —
Pn524
Reserved
— — — —
Pn525
Overload alarm threshold % 100~150 100 Immediately
Pn526
Temperature threshold of motor overheat
alarm
（Only enabled in ProNet–75/1A/1E/2B）
℃
50~180 110 Immediately
Pn528 Output signal inverse — 0~1111 0 Immediately
Pn529
Torque detection output signal threshold
value
% 3~300 100 Immediately
Pn530 Torque detection output signal time ms 1~1000 10 After restart
Pn600
Position pulse in point to point control 10000P -9999~9999 0 Immediately
Pn601
Position pulse in point to point control 1P -9999~9999 0 Immediately
……
Pn630
Position pulse in point to point control 1P -9999~9999 0 Immediately
Pn631
Position pulse in point to point control 1P -9999~9999 0 Immediately
Pn632
Point to point speed control rpm 0~3000 500 Immediately
……
Pn647
Point to point speed control rpm 0~3000 500 Immediately
Pn648
Point to point 1st order filter 0.1ms 0~32767 0 Immediately
……
Pn663
Point to point 1st order filter 0.1ms 0~32767 0 Immediately
Pn664
Stop time 50ms 0~300 10 Immediately
……
Pn679
Stop time 50ms 0~300 10 Immediately
Pn680
Reserved
— — — —
Pn681
Hex
Pn681.0:Single/cyclic, start/reference point
— 0~0x0133 0x0000 Immediately