Esu 58410 - Page 99

99
List of all supported CVs List of all supported CVs
CV Surname description range value
49 Advanced Configuration # 1 0 Load control active
load control Off
10 0 - 255 19
1 Reserved 2
2 Reserved 4
3 Märklin® subsequent addresses, "low" bit 0, 8
4 Automatic driving steps recognition speed steps
recognition DCC format off speed steps recognition DCC
switched format
0
16
5 LGB® function keys mode LGB®
mode off LGB® mode switched 0
32
6 Reserved 64
7 Märklin® subsequent addresses, "high" bit
Note Section 9.3.1. Declaration for bits 3, 7
0, 128
50 analog mode Determines which analogue modes are permitted 0-3 3
bit function value
0 AC analog mode AC analog mode off
AC analog mode is on 01
1 DC analog mode DC analog mode off
DC analog mode is on 02
2 turned QSI Quantum Engineer in DC analog mode QSI
Quantum Engineer recognition off QSI Quantum Engineer
recognition
04
51 "K Slow" Cutoff Internal speed step up to the "Slow K" applies 0 - 255 10
52 Load control. "K Slow" "K" portion of the internal PI controller for the low speed steps 0 - 255 10
53 control reference Determines the level of back EMF voltage to supply the motor at maximum speed overall.
The better the efficiency of the engine, the higher this value may be. If the engine does
not reach maximum speed, increase this parameter.
0-255130