EUCHNER CTS-C1-BP-FLX

To Next Page

To Previous Page

MAN20001587-01-02/23 (translation of the original operating instructions)

Operating Instructions

Transponder-Coded Safety Switch CTS-C1-BP/BR-FLX

Main Page

Table of Contents2
About this Document4
Scope4
Target Group4
Key to Symbols4
Supplementary Documents4
Correct Use5
Description of the Safety Function7
With Active Guard Lock Monitoring7
With Inactive Guard Lock Monitoring8
Exclusion of Liability and Warranty9
General Safety Precautions9
Function10
Guard Lock Monitoring10
Monitoring Outputs/Status Bits10
Guard Locking Signal OL10
Door Position 1 Signal OD10
Door Position 2 Signal OT11
Diagnostic Signal OI11
Escape Release Signal OER11
Status Signal OM11
Locking Element Signal OLS11
Communication Connection C11
Guard Locking11
Switching States12
Manual Release13
Auxiliary Release13
Actuating Auxiliary Release13
Escape Release14
Actuating Escape Release14
Mounting15
Electrical Connection18
Notes about19
Safety in Case of Faults19
Fuse Protection for Power Supply19
Requirements for Connecting Cables20
Connector Assignment/Terminal Assignment of Safety Switch CTS21
Connector Assignment of Safety Switch CTS21
Notes on Operation with Safe Control Systems22
Connection Without and with IO-Link Communication22
Connection Without IO-Link Communication22
Connection with IO-Link Communication22
Connection of a Single CTS-C1-BP/BR-FLX (Separate Operation)23
Connection of Several Devices in a Chain (Series Connection)24
Series Connection with Wiring in the Control Cabinet24
Series Connection with Y-Distributors24
Maximum Cable Lengths with BR Switch Chains25
Determining Cable Lengths Using the Example Table25
Connector Assignment of Y-Distributor for Series Connection Without IO-Link Communication26
Connector Assignment of Y-Distributor for Series Connection with IO-Link Communication28
Using Communication Data29
Connection to a BR/IO-Link Gateway GWY-CB29
Connection to a Safety Relay ESM-CB29
Overview of the Communication Data30
Cyclical Data (Process Data)30
Acyclical Data (Device Data and Events)30
Setup32
Configuring Device and Teaching-In Actuator for the First Time32
Teaching-In New Actuator (Only for Evaluation of the Actuator with a High Coding Level)33
Functional Check34
Mechanical Function Test34
Electrical Function Test34
Factory Reset35
Status and Error Messages35
LED Displays35
Status Messages36
Error Messages37
Acknowledging Error Messages39
Technical Data40
Technical Data for Safety Switch CTS-C1-BP/BR-FLX40
Typical System Times42
Radio Frequency Approvals43
Dimension Drawing for Safety Switch CTS44
Technical Data for Actuator A-FLX-D-045
Dimension Drawing for Actuatora-FLX-D-045
Ordering Information and Accessories46
Inspection and Service46
Service46
Declaration of Conformity46

EUCHNER CTS-C1-BP-FLX - Page 47

Table of Contents

Related product manuals