EUCHNER CTS-C1-BP-FLX - Exclusion of Liability and Warranty; General Safety Precautions

9
MAN20001587-01-02/23 (translation of the original operating instructions)
Operating Instructions
Transponder-Coded Safety Switch CTS-C1-BP/BR-FLX
EN
4. Exclusion of liability and warranty
In case of failure to comply with the conditions for correct use stated above, or if the safety regulations are not followed,
or if any servicing is not performed as required, liability will be excluded and the warranty void.
5. General safety precautions
Safety switches fulll personnel protection functions. Incorrect installation or tampering can lead to fatal injuries to personnel.
Check the safe function of the safeguard particularly
Ì after any setup work
Ì after the replacement of a system component
Ì after an extended period without use
Ì after every fault
Ì after any reconguration of the device
Independent of these checks, the safe function of the safeguard should be checked at suitable intervals as part of the
maintenance schedule.
WARNING
Danger to life due to improper installation or due to bypassing (tampering). Safety components fulll
a personnel protection function.
Ì Safety components must not be bypassed, turned away, removed or otherwise rendered ineffective.
On this topic pay attention in particular to the measures for reducing the possibility of bypassing
according to ENISO14119:2013, section 7.
Ì The switching operation must be triggered only by actuators designated for this purpose.
Ì Prevent bypassing by means of replacement actuators (only for low coding level evaluation). For this
purpose, restrict access to actuators and to keys for releases, for example.
Ì Make sure the guard cannot be closed unintentionally, e.g. during servicing. For this purpose, a
lockout bar can be used, for instance.
Ì Mounting, electrical connection and setup only by authorized personnel possessing the following
knowledge:
- specialist knowledge in handling safety components
- knowledge about the applicable EMC regulations
- knowledge about the applicable regulations on operational safety and accident prevention.
NOTICE
Risk of damage
Ì The guard locking function can no longer be ensured if an actuator is broken. Opening the door will
immediately switch off the safety outputs. Regularly check the actuator for mechanical damage.
Important!
Prior to use, read the operating instructions and keep these in a safe place. Ensure the operating
instructions are always available during mounting, setup and servicing. You can download the operating
instructions from www.euchner.com.