EUCOL U2836 - Chapter 6: Performance and Test Procedures; Test Functions and Signal Characteristics

U2836 Operation Manual Chapter 5 Execute LCR operation and some examples
43
Chapter 6 Performance and Test
6.1 Test function
6.1.1 Parameter and symbol
C：capacitance L：Inductance
R：resistance Z：impedance Y：Admittance
X：reactance B：susceptance G：Conductance
D：dissipation θ：phase angle Q：Quality factor
6.1.2 Test combination
Parameters described above are combined in the following modes:
Primary parameter
Z，Y L，C
R G
Secondary parameter
θ（deg phase），θ（rad radian）
D，Q，R
S
，R
P
，G
X B
6.1.3 Mathematical operation
Operation between the measurement value and the programmable nominal value:
absolute deviation ∆ABS and percent deviation ∆%.
6.1.4 Equivalent mode
Series and parallel
6.1.5 Range
Auto, Manual (Hold, increase and decrease)
6.1.6 Trigger
Internal, external and manual
Internal: Test DUT constantly and display the result
Manual: Press TRIGGER to test once then the result will be displayed.
External: After HANDLER receiving “start” signal， perform a measurement and
output test result.