AUDIO | VIDEO MEDIA CONTROLLER
USER GUIDE
SURFACE CONTROLS
34
INSERTS
Pressing the INSERTS key displays the inserts knob set for editing plug-ins. The
first plug-in is displayed on the knob. Pressing one of these Knob Tops displays
the first eight plug-in parameters for editing. Pressing a plug-in’s Knob Top
displays its parameters for editing.
EQ
Press the EQ key to display the EQ knob set to configure equalization controls
and filters. This shows four EQ bands on eight knobs.
AUX
Press the AUX key to display the Aux knob set to control auxiliary sends. The first
aux send is displayed. Up to eight aux sends can be shown at once.
PAN
Press the PAN key to display the Pan knob set to configure left/right or surround
panning. The left/right pan control is typically displayed. The first page of eight
pan knobs is shown.
INPUT
Press the INPUT key to display the Input knob set to configure input routing, mic
gains, phantom power, and other application-specific parameters.
DYN
Press the DYN key to display the Dynamics knob set to configure compressors,
limiters, expanders, and gates.
GROUP
Press the GROUP key to display the Group knob set to configure group bus routing
or control group (VCA) membership.
MIX
Press the MIX key to display the Mix knob set to configure output routing.
To Next Page
Loading...
Need help?
General
