Figure 14: Pad dimensions
Required Utility Services
Electrical - Have a qualified electrician install electrical service. The machine requires a 208-230
VAC, Single Phase, 60Hz, 30 Amp service. A 10-foot power cord is supplied to connect to a 30
Amp breaker. The machine does not ship with a plug. Follow and comply with all local electric
codes.
Warning: Should your local code require the machine to be connected to a GFCI Breaker,
use only a GFCI with select current sensor sensitivity of 200 mA, and not < 0.1 second
detection to avoid nuisance tripping. For more information on this, please refer to the VFD
Manual that was provided with your machine. If that is not accessible, please reach out to
Everest’s service department.
Water - The machine is intended for connection to an Inspected and approved water system
only. The filtration system in the machine is not rated to use non-potable water. It is essential
that the supply source is from a municipal approved source and/or that the water source is
tested and approved for healthy consumption before it enters the machine’s filtration system.
The filtration system will then refine and improve the quality. The filtration system is not
designed to turn unsafe, undrinkable water into safe drinkable water.
To Next Page
Loading...