EasyManua.ls Logo

Everest VX - Everest Ice and Water Systems Warranty

Everest VX
71 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EVEREST ICE AND WATER SYSTEMS
WARRANTY
MANUFACTURER’S LIMITED WARRANTY Everest Ice and Water Systems (“Everest”)
warrants to the original buyer (“Buyer”) that ice and water vending machines of its manufacture
will be free from defects in material and/or workmanship. Everest further warrants that these
machines will perform adequately under normal use if properly installed and maintained in
accordance with the operating manuals furnished with the product.
Applicable Products/Models: The following Everest models are covered under this warranty:
VX1, VX2, VX3, VX4, Vortex 500
Warranty Starting Time: This product warranty begins on the date that the machine has shipped
from the factory.
Geographic Limitation: None. This warranty is applicable worldwide. Warranty is for Parts Only,
Not Labor: This warranty covers parts only. It does not cover labor.
What is Not Covered: This warranty does not cover the commercial ice cuber, credit card reader,
coin manager, or bill validator. These items are either purchased directly by Everest and
installed into the machine for the customer. The warranties for these products will be handled by
and is the sole responsibility of the respective product manufacturer.
What is Covered: This warranty covers: • Main drive systems (barrel, barrel saddle, gear drive,
barrel motor) for 12 months • Main machine structural component (frame) for 12 months • Main
plumbing systems (water manifold, tubing, fittings) for 12 months • Main electrical components
for 12 months • All other components (excluding aforementioned noncovered products) for 12
months
Buyer’s Obligations: The product must be installed, cleaned and maintained as described in the
Operating Manual furnished with the product. The commercial ice machine must be cleaned and
maintained as described in the separate Manufacturer’s Operating Manual furnished with the
product. Any replacement parts must be genuine Everest replacement parts or from a third party
approved source. Failure to meet these obligations shall result in voiding of warranty.
Everest’s Obligation: Upon return of any defective, warrantied parts to the factory, Everest shall,
at no cost to Buyer, analyze the parts and repair or replace any part or parts found to be
defective in material and/or workmanship during the warranty period. All decisions regarding
68
Vb000122015

Table of Contents