19
1919
19
8. TIME SYNCHRONIZE
Select “ON” or “OFF” to enable or disable time synchronize, which will update the correct
time automatically when network is connected. To change this, simply use the Jog Dial
on the DVR.
9. TIME SERVER
You can set the time server address that the DVR connects to for time synchronize. To
find the IP address of NTP Server, please follow these steps:
a) Go to a PC that is connected to the internet.
b) Click on “START” -> “RUN” -> type “cmd” and press “OK”.
To set the starting time change of daylight saving time: Choose the “FROM” time
and “TO” time when daylight savings starts.
7. END TIME
To set the end time of daylight saving time.
To set the ending time change of daylight saving time: Choose the “FROM” time
and “TO” time when daylight savings ends.
To set the end week of daylight saving time: Dial the jog to set the end week.
To set the end date of daylight saving time: Dial the jog to set the end date.
To set the end month of daylight saving time: Dial the jog to set the end month.
FEB
To Next Page
Loading...
