EverFocus EDVR16D1 - 7 Call Overview

72
7272
72
7. Call Overview
This chapter will try to give you details on how to setup the CALL MENU on the DVR.
Press the CALL key and the CALL MENU will pop up as below.
Diagram 7.1
In CALL MENU, you can do the following settings for the selected monitor:
1. SEQ: Sequence display on the call monitor. Press SEQ key or Middle wheel of
mouse to switch the sequence status “ON” or “OFF”.
2. OSD: Channel name display on the call monitor. Press DISPLAY key or right click
the mouse to switch the OSD status “ON” or “OFF”.
3. CAMERA: The current display camera in the call monitor. Press Channel NO or
slide wheel of mouse to set display camera.
4. Sequence dwell time setting
Turn the jog dial to enter SEQUENCE DWELL TIME MENU.
Chapter
7
CALL MENU
▲
▲ ▲
▲
____________________________________________________
MONITOR SEQ OSD CAMERA
CALL MON OFF ON 01
SEQUENCE DWELL TIME SETTING
PRESS SEQ/MIDDLE TO ON/OFF SEQ
PRESS DISPLAY/RIGHT TO ON/OFF OSD
PRESS CHANNEL NO/WHEEL TO SET CAMERA