32
3232
32
3. LOG
YES: Select YES if you wish to record Motion Events log to the HDD.
NO: Select NO if you do not wish to record Motion Events log to the HDD.
4. DURATION
The amount of time a motion event will record - from 1 sec to 99 seconds. The default
value is 5 seconds. To change this, simply use the Jog Dial on the DVR.
5. ALARM OUTPUT
This will transmit a signal to another device. The setting of alarms are NONE = not
activated, 1 = output signal 1 transmits, 2 = output signal 2 transmits, 3 = output
signal 3 transmits and 4 = output signal 4 transmits. To change this, simply use the
Jog Dial on the DVR.
(Only EDVR16D3 model has 4 alarm outputs, all others have only 1 alarm output)
6. ALARM EMAIL
YES: Send an email when an alarm occurs.
NO: Do not send an email when an alarm occurs.
The email address and email server can be set in the NETWORK SETUP MENU.
7. ALARM NETWORK
YES: Enable alarm network when an alarm occurs.
NO: Disable alarm network when an alarm occurs.
8. BUZZER: Audible buzzer when motion is detected.
ENABLE: To enable a motion buzzer.
DISABLE: To disable a motion buzzer.
9. MOTION DELAY:
Select motion delay time from 0~7 level.
10. MAIN MON: Display on main monitor when motion occurs.
NO CHANGE: No change on the main monitor display when a motion occurs.
FULLSCREEN: A full screen of the active camera will display when motion occurs.
11. CALL MON: Display on a call monitor when motion occurs.
NO CHANGE: No change on the call monitor display when motion occurs.
ACTIVE CAMERA: Display the active camera that is set for Motion in full screen
mode to the call monitor.
To Next Page
Loading...
