EverFocus EDVR16D1 - Page 62

52
5252
52
2. ALARM OUTPUT
This will transmit a signal to another device. The setting of alarms are NONE = not
activated, 1 = output signal 1 transmits, 2 = output signal 2 transmits, 3 = output
signal 3 transmits and 4 = output signal 4 transmits. To change this, simply use the
Jog Dial on the DVR.
(Only EDVR16D3 model has 4 alarm outputs. All others have only 1 alarm output).
3. ALARM DURATION
Permanent. This setting cannot be changed.
4. NETWORK ALARM
YES: To enable network alarm.
NO: To disable network alarm.
5. SEND EMAIL
YES: Send an email when HDD’s temperature is overheated.
NO: Will not send an email when HDD’s temperature is overheated.
The email settings can be set in the NETWORK SETUP MENU.
6. STOP RECORD
YES: Stop recording when HDD’s temperature is overheated.
NO: Will not stop recording even when HDD’s temperature is overheated.
7. SET TEMPERATURE:
When HDD’s temperature is higher than the temperature set here, all other active
settings in HDD TEMP will take effect (BUZZER, ALARM OUTPUT, ALARM
DURATION, NETWORK ALARM, SEND EMAIL, STOP RECORD). The default value is
60°C (140°F).