evertz HDSD9545DLY-PRO - Preset Key Group; Setup Key Group; Front Panel Display Messages

HDSD9545DLY - PRO Profanity Bypass Delay Manual
Page 3-2 Revision 1.3.7 OPERATION
3.1.2. Preset Key Group
Preset 1 to 4 These four buttons allow the user to quickly change the configuration of the
HDSD9545DLY-PRO. There are 10 user presets that can be stored in the non-volatile
memory. Pressing button 1 to 4 will recall user presets 1 to 4. The remaining presets can only
be recalled using the Recall Preset menu. The button caps can be removed to allow the user
to provide his own legends for the buttons.
3.1.3. Setup Key Group
SETUP This button is used to enter the Setup menu that is used to control various setup options to
configure the operating modes of the HDSD9545DLY-PRO. (See sections 3.3 to 3.13 for a
complete description of the Setup menu.) When you are in the Setup menu, this button is also
used to back out of menu selections to the next higher menu level or to exit the Setup menu
completely.
SELECT This button is used to choose a sub-menu and navigate to the next level down in the menu
structure. It is also used to make a menu choice.
↑ & ↓ The arrow keys are used to navigate through various menu choices at a menu level in the
Setup menu.
3.1.4. Front Panel Display Messages
In addition to the normal operating mode displays that show the names of the inputs that have been
selected, the HDSD9545DLY-PRO shows some diagnostic messages to help the user diagnose possible
system problems.
The front panel will automatically display the following messages describing the following video and audio
settings:
V: XXXX A: XXXX Displays the current video and audio source on the on-air path (either Pgm or
Safe)
INPUT-A FAULT Indicates that video input A does not have a proper signal.
GENLOCK FAULT Indicates that a Video Reference signal specified in the VIDEO CONFIG menu is
not present at the Video Ref input BNC.