evertz HDSD9545DLY-PRO - Setting the Amount of Blur on the Program Delayed Video; Setting the Amount of Blur on the Safe Delayed Video; Configuring the Audio

HDSD9545DLY - PRO Profanity Bypass Delay Manual
Page 3-16 Revision 1.3.7 OPERATION
3.10.6. Setting the Amount of Blur on the Program Delayed Video
VIDEO
Pgm Blur Factor
PgmBF:0 to 8
PbmBF:8
This control enables the user to set the amount of blurring that will be applied
to the delayed program video when the pgm blur or t pgm blur transition is
selected.
Increasing the value will increase the amount of blurring.
3.10.7. Setting the Amount of Blur on the Safe Delayed Video
VIDEO
Safe Blur Factor
SafBF:0 to 8
SafBF:8
This control enables the user to set the amount of blurring that will be applied
to the delayed safe video when the safe blur or t safe blur transition is
selected.
Increasing the value will increase the amount of blurring.
3.11. CONFIGURING THE AUDIO
The AUDIO menus are used to configure the audio reference, and SoftSwitch™ settings for each of the
audio channel pairs. The chart below shows the items available in the AUDIO menu. Sections 3.11.1 to
3.11.2 provide detailed information about each of the sub-menus.
AES 1 SS
Selects whether SoftSwitch™ is enabled for the AES A 1 pair
AES 2 SS
Selects whether SoftSwitch™ is enabled for the AES A 2 pair
AES 3 SS
Selects whether SoftSwitch™ is enabled for the AES A 3 pair
AES 4 SS
Selects whether SoftSwitch™ is enabled for the AES A 4 pair
Embed Audio SS
Selects whether SoftSwitch™ is enabled for the embedder group 1-4 audio