HDSD9545DLY - PRO Profanity Bypass Delay Manual
TECHNICAL DESCRIPTION Revision 1.3.7
CHAPTER 4: TECHNICAL DESCRIPTION
TABLE OF CONTENTS
4. TECHNICAL DESCRIPTION............................................................................................................ 4-1
4.1. SPECIFICATIONS................................................................................................................... 4-1
4.1.1. Serial Digital Video Inputs ............................................................................................ 4-1
4.1.2. Serial Digital Video Outputs ......................................................................................... 4-1
4.1.3. Video Reference ..........................................................................................................4-1
4.1.4. DARS Reference (not implemented at the time of writing)........................................... 4-2
4.1.5. AES Audio Inputs .........................................................................................................4-2
4.1.6. AES Audio Outputs ...................................................................................................... 4-2
4.1.7. GPI Control Port........................................................................................................... 4-2
4.1.8. Remote Control Port..................................................................................................... 4-2
4.1.9. Functional..................................................................................................................... 4-2
4.1.10. Electrical....................................................................................................................... 4-3
4.1.11. Physical........................................................................................................................ 4-3
4.2. SERVICING INSTRUCTIONS ................................................................................................. 4-3
4.2.1. Changing the Fuses ..................................................................................................... 4-3
4.2.2. JUMPERS .................................................................................................................... 4-4
4.2.2.1. Configuring the Unit for a DARS Reference
(DARS reference not implemented at the time of writing) ............................. 4-4
4.2.2.2. Configuring the Module for Firmware Upgrades
using the Serial Port Method ......................................................................... 4-4
4.3. UPGRADING FIRMWARE ...................................................................................................... 4-4
4.3.1. Upgrading the Firmware using FTP ............................................................................. 4-5
4.3.1.1. Step 1 – Determine the IP Addresses ........................................................... 4-5
4.3.1.2. Step 2 – Establishing a Valid Network Connection ....................................... 4-6
4.3.1.3. Step 3 – Upgrading the Application Code ..................................................... 4-7
4.3.1.4. Step 4 – Completing the Upgrade ................................................................. 4-8
4.3.2. Upgrading the Firmware using RS-232 Serial Cable ................................................... 4-8
4.3.2.1. Step 1 – Setup............................................................................................... 4-8
4.3.2.2. Step 2 – Invoke Upload Mode from the Terminal Program ........................... 4-9
4.3.2.3. Step 3 – Uploading the New Firmware.......................................................... 4-9
4.3.2.4. Step 4 – Completing the Upgrade ............................................................... 4-10
To Next Page
Loading...
