Summit WM User Guide, Software Version 5.3 223
Figure 19: WDS Deployment
NOTE
With the single WDS WM-AD, the tree structure for the WDS deployment will be as depicted on the bottom right of
Figure 19. You can also implement the same deployment using four WDS WM-ADs, each for a set of Altitude APs in
the four corners of the building. Each set of Altitude APs will form an isolated topology and will operate using a
separate SSID and a separate Pre-shared key. For more information, see "WDS WM-AD" on page 214.
To configure the WDS Altitude APs through the Summit WM Controller:
NOTE
You must identify and mark the Preferred Parents, Backup Parents and the Child Altitude APs in the proposed WDS
topology before starting the configuration process.
1 From the main menu, click WM Access Domain Configuration. The WM Access Domain
Configuration page is displayed.
2 In the left pane, type the WDS WM-AD name in the Add subnet box.
3 Click Add subnet. The name is displayed in the WM Access Domains list and the To polo gy tab is
displayed.
z The solid arrows
point towards
Preferred Parents.
z The dotted arrows
point towards
Backup Parents.
To Next Page
Loading...
