Extreme Networks Summit WM - Page 74

Configuring the Altitude AP
Summit WM User Guide, Software Version 5.374
Center LED
The Center LED indicates the general status of the Altitude AP:
Left LED
The Left LED indicates the high-level state of the Altitude AP during the initialization and discovery
process:
Left and Right LEDs
The Right LED indicates the detailed state during the initialization and discovery processes:
Composite view of the three LEDs
The Center, Left and the Right LEDs work in conjunction to indicate the general, high-level state and
the detailed state respectively.
Table 5: Center LED and Altitude AP's status
Center LED Altitude AP's status
Blinking Green Initialization and discovery in progress via Ethernet link
Blinking Orange/Amber Initialization and discovery in progress via WDS link
Blinking Red Error during initialization/discovery process
Solid Red Irrecoverable error
Solid Green Discovery finished via Ethernet link
Solid Orange/Amber Discovery finished via WDS link
Table 6: Left LED and Altitude AP's high-level state
Left LED Altitude AP's high-level state
Off Initialization
Blinking Green Network Discovery
Solid Green Connecting with the Summit WM Controller
Table 7: Left and Right LEDs and Altitude AP's detailed state
Left LED Right LED Altitude AP's detailed state
Off Off Initialization: Power-on self-test (POST)
Blinking Green Initialization: Random delay
Solid Green Initialization: Vulnerable period
Blinking Green Off Network Discovery: 802.1X authentication
Blinking Green Network Discovery: Attempting to obtain IP address via DHCP
Solid Green Network Discovery: Discovered Summit WM Controller
Solid Green Off Connecting to Summit WM Controller: Attempting to register with the
Summit WM Controller
Blinking Green Connecting to Summit WM Controller: Upgrading to higher version
Solid Green Connecting to Summit WM Controller: Configuring itself