Extreme Networks Summit WM - Page 75

Summit WM User Guide, Software Version 5.3 75
The following table provides a composite view of the three LED lights of the Altitude AP's state:
NOTE
The Left and Right LEDs turn on after the center LED. This allows you to distinguish easily between the Center LED
and the Left/Right LEDs.
NOTE
If the Center LED begins blinking RED, it indicates that the Altitude AP's state has failed.
NOTE
Random delays do not occur during normal reboot. A random delay only occurs after vulnerable period power-down.
Table 8: Composite view of three LED lights
Left LED Right LED Center LED Altitude AP's Detailed state
Off
Off Blinking Green Initialization: Power-on self-test (POST)
Blinking
Green
Blinking Green Initialization: Random delay
Blinking Red Initialization: Neither Ethernet nor WDS link
Solid Green
Blinking Green Initialization: Vulnerable period
Blinking Red Reset to factory defaults
Solid Green Blinking Orange WDS scanning
Blinking
Green
Off
Blinking Green /
Orange
Network discovery: 802.1x authentication
Blinking Red Failed 802.1x authentication
Blinking
Green
Blinking Green /
Orange
Network discovery: DHCP
Blinking Red Default IP address
Solid Green
Blinking Green /
Orange
Network discovery: WM discovery / connect
Blinking Red Discovery failed
Solid
Green
Off
Blinking Green /
Orange
Connecting with Summit WM Controller: Registration
Blinking Red Registration failed
Blinking
Green
Blinking Green /
Orange
Connecting with Summit WM Controller: Image upgrade
Blinking Red Image upgrade failed
Solid Green
Blinking Green /
Orange
Connecting with Summit WM Controller: Configuration
Blinking Red Configuration failed
Blinking
Green
Solid Green /
Orange
AP operating normally: Forced image upgrade
Blinking Red Image upgrade failed