Configuring the Altitude AP
Summit WM User Guide, Software Version 5.376
The Altitude AP can be reset to its factory default settings. For more information, see the Summit WM Maintenance
Guide.
Outdoor AP LED status
The following figure depicts the location of the LEDs on the Outdoor AP.
Figure 8: Outdoor AP LEDs
NOTE
Although the Outdoor AP has six LEDS, only R1, R2 and F LEDs are used in the current release. The remaining
LEDs are disabled.
The Center, Left, and the Right LEDs work in conjunction to indicate the general, high-level and
detailed state respectively.
The following table provides a composite view of the three LED lights of the Outdoor AP's state:
Table 9: Outdoor AP LED status
R1 LED R2 LED F LED Outdoor AP's detailed status
Off Off Blinking Red Initialization: Power-on-self test (POST)
Blinking Green Blinking Red Initialization: Random delay
Solid Green Blinking Red Initialization: Vulnerable Period
Solid Red Reset to factory defaults
Solid Green Blink Red WDS scanning
Blinking
Green/
Yellow
Off Blinking Red Network discovery: 802.1X authentication
Solid Red Failed 802.1X authentication
Blinking Green/
Yellow
Blinking Red Network discovery: DHCP
Solid Red Default IP address
Solid Green/
Yellow
Blinking Red Network discovery: WM discovery/connect
Solid Red Discovery failed
To Next Page
Loading...
