Summit WM User Guide, Software Version 5.3 77
NOTE
After discovery is finished, the Left and Right LEDs will be Green for Ethernet uplink, and Yellow for WDS uplink.
NOTE
If the fatal AP error occurs, the Status LED will be solid Red.
Altitude 802.11n AP LED status
Figure 9 depicts the location of the LEDs on the Altitude 802.11n AP.
Figure 9: Altitude 802.11n AP LEDs
The LEDs, L1, L3 and L4 work in conjunction to indicate the general, high-level, and detailed state
respectively.
Solid
Green
Off Blinking Red Connecting with WM: Registration
Solid Red Registration failed
Blinking Green/
Yellow
Blinking Red Connecting with WM: Image upgrade
Solid Red Image upgrade failed
Solid Green/
Yellow
Blinking Red Connecting with WM: Configuration
Solid Red Configuration failed
Blinking Green/
Yellow
Off AP operating and running normally: Forced image upgrade
Solid Red Image upgrade failed
Table 9: Outdoor AP LED status (Continued)
R1 LED R2 LED F LED Outdoor AP's detailed status
To Next Page
Loading...
