Extreme Networks VSP 4900 Series User Manual

3. Push the latching tab toward the power supply handle and pull outward on the
handle to disengage the power supply internal connectors.
See Figure 32.
Figure 32: Removing an 1100 W AC Power Supply
4. Carefully slide the power supply the rest of the way out of the switch.
Caution
Power supplies can become very hot during operation. Wear thermal
protective gloves when you remove a power supply from an operating
switch.
Note
If you are not installing a replacement power supply, install a cover over the
unoccupied power supply bay. Unoccupied bays must always be covered to
maintain proper system ventilation and EMI levels.
5. Verify that the replacement power supply is oriented the same way as the unit you
removed, and has the same airow direction.
Removing and Replacing Components Replace an 1100 W AC Power Supply
VSP 4900 Series Switches: Hardware Installation Guide 65

Extreme Networks VSP 4900 Series Specifications

General

Brand	Extreme Networks
Model	VSP 4900 Series
Category	Switch
Language	English