Extron electronics IN1804 Series - Page 87

IN1804 Seamless Scaling Switchers • SIS Configuration and Control 79
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Information Requests (continued)
Query part number
N
X3^]
Verbose modes 2 and 3:
Pno
X3^]
View unit part number
X3^
for the model.
View internal temperature
E
20STAT
}
X1@]
Verbose modes 2 and 3:
20Stat•
X1@ ]
View unit internal temperature
X1@
in
degrees Celsius.
Set verbose mode
EX3$
CV
}
Vrb
X3$]
Set the verbose mode to
X3$
, with or
without tagged responses.
View verbose mode
E
CV
}
X3$]
View the current verbose mode.
KEY:
X1@
= Internal temperature
In degrees Celsius. Response is two digits, padded with a zero.
X3$
= Verbose mode (see the verbose mode
command description on page 55 for
more information)
0 = None (default for LAN connection)
1 = Verbose mode (default for RS-232 and USB connection)
2 = Tagged responses to queries
3 = Verbose mode and tagged responses
X3^
= Part number
IN1804 (standard) — 60-1699-01 or 60-1699-11
IN1804 DI — 60-1699-02 or 60-1699-12
IN1804 DO — 60-1699-03 or 60-1699-13
IN1804 DI/DO — 60-1699-14
IP Control Port Commands
IP Setup
NOTES:
• Changes made to any TCP/IP settings do not take effect until the reboot network command (
E
2BOOT
}
) is issued.
• The following IP address setup commands that are followed by
24
require Administrator permission to enter. Attempts to
issue them without Administrator status result in an E24 (privilege violation) error message.
Set DHCP mode
24
EX1)
DH
}
Idh
X1)]
Enable or disable DHCP.
View DHCP mode
E
DH
}
X1)]
View the DHCP mode setting.
Set IP address
24
EX8&
CI
}
Ipi
•
X8&]
Set the IP address to
X8&
.
Read IP address
E
CI
}
X8&]
View the current IP address.
Set subnet mask
24
EX8(
CS
}
Ips
•
X8(]
Set the subnet mask to
X8(
.
View subnet mask
E
CS
}
X8(]
View the subnet mask setting.
Set gateway IP address
24
EX8*
CG
}
Ipg
•
X8*]
Set the gateway IP address to
X8*
.
View gateway IP address
E
CG
}
X8*]
View the gateway IP address setting.
KEY:
X1)
= On or off, enable or disable
0 = DHCP disabled (default), 1 = DHCP enabled
X8&
= IP address
Format nnn.nnn.nnn.nnn (192.168.254.254 = default)
Leading zeros in each of the four octets are optional in setting values,
and are suppressed in returned values.
X8*
= Gateway address
nnn.nnn.nnn.nnn (0.0.0.0 = default)
X8(
= Subnet mask
nnn.nnn.nnn.nnn (255.255.255.0 = default)
X9)
= Hardware (MAC) address
00-05-A6-xx-xx-xx