Extron electronics IN1804 Series - Page 88

IN1804 Seamless Scaling Switchers • SIS Configuration and Control 80
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
IP Control Port Commands (continued)
IP Setup (continued)
View MAC address
E
CH
}
X9)]
Verbose modes 2 and 3:
Iph
•
X9)]
View unit Media Access Code (MAC)
address
X9)
.
Set LAN IP address,
subnet mask, and gateway
address
24
E
1*
X8&
/
X9#
*
X8*
CISG
}
Cisg 1*
X8&
/
X9#
*
X8*]
Set the IP address to
X8&
for the LAN
port (1), the subnet mask prefix to /
X9#
,
and the gateway address to
X8*
at the
same time.
NOTE: Setting any values with a CISG command changes the DHCP setting to Off and the Cisg response is followed by
Boot2 response (when the unit is in verbose mode 2 or 3).
View all IP settings
E
1CISG
} X8&
/
X9#
*
X8*]
View the IP address, subnet mask
(prefix), and gateway address of the unit.
Query the number of open
connections
E
CC
}
X8^]
Verbose modes 2 and 3:
Icc
X8^]
View the number of open connections.
Reboot networking
E
2BOOT
}
Boot2
]
Restart the network after IP setting or
DHCP changes.
Set unit name
EX8!
CN
}
Ipn•
X8!]
Assign a name for the unit.
Set unit name to factory
default
E
•CN
}
Ipn•
X9@]
Reset the unit name to its factory default
name.
View unit name
E
CN
}
X8!]
View current unit name
X8!
.
KEY:
X1)
= On or off, enable or disable
0 = DHCP disabled (default), 1 = DHCP enabled
X8!
= Unit name
A text string of up to 32 characters.
• A-Z, 0-9, and the hyphen (–) are permitted.
• The first character must be a letter.
• The last character cannot be a hyphen.
• No distinction is made between uppercase and lowercase letters.
• Space or blank characters are not permitted.
X8^
= Number of open connections
0-<maximum number of open connections>
X8&
= IP address
Format nnn.nnn.nnn.nnn (192.168.254.254 = default)
Leading zeros in each of the four octets are optional in setting values,
and are suppressed in returned values.
X8*
= Gateway address
nnn.nnn.nnn.nnn (0.0.0.0 = default)
X8(
= Subnet mask
nnn.nnn.nnn.nnn (255.255.255.0 = default)
X9)
= Hardware (MAC) address
00-05-A6-xx-xx-xx
X9@
= Default unit name
Combination of the model name and the last three hexadecimal
character pairs of the unit MAC address.
Example: IN1804-DO-14-9A-B0.
X9#
= Subnet mask in CISG commands
Prefix representing subnet mask bits (subnet mask value in CISG
commands).
Default = /24, which represents the default subnet mask,
255.255.255.0.