Extron electronics SSP 200 - Page 76

SSP 200 • SIS Configuration and Control 68
Output Channels Table
1 Height Pair
(no Downmix)
2 Height Pairs
(no Downmix)
0 Height +
Downmix
1 Height Pair +
Downmix
1 Left front Left front Left front Left front
2 Right Front Right Front Right Front Right Front
3 Center Center Center Center
4 Subwoofer Subwoofer Subwoofer Subwoofer
5 Left Surround Left Surround Left Surround Left Surround
6 Right Surround Right Surround Right Surround Right Surround
7 Left Back Left Height Front Left Back Left Height Front
8 Right Back Right Height Front Right Back Right Height Front
9 Left Height Front Left Height Back Downmix L Downmix L
10 Right Height Front Right Height Back Downmix R Downmix R
X5*
= dB value: –24 to 0 (default 0)
X6)
= Audio Mute: 0 = Mute off (default) 1 = Mute on
X6@
= %: 0 to 100 (default 80)
X6%
= dB value: –18 to +24 (default 0)
X6&
= Executive mode number
0 = Unlock front panel (default)
1 = Lock front panel
2 = Limit front panel to volume control
3 = Limit front panel to input selection
X7&
=
Slot number: 1 = HDMI input 2 = Loop Thru
X7*
= 128 or 256 byte EDID raw HEX (text form) from currently assigned EDID.
X7(
= Native resolution and refresh rate from currently assigned EDID, for example: 1920x1080
@60 Hz.
X8!
= Connection status:
0 = Not connected
1 = Connected
X8(
= Offset: 0-3000, 10x time value, from 0.0 to 300.0 milliseconds
X9)
= Mono output mode:
1 = Center channel only (default)
2 = Front left and right only
X9#
= Subwoofer mode:
0 = All off
1 = LFE (SUB) (default)
X9*
= Listening mode:
1 = Auto (follow source) 5 = Mono to all
2 = Stereo 6 = Dolby Surround (Upmixer)
3 = Mono 7 = DTS Neural: X (Upmixer)
4 = Stereo to all
X10(
= Volume level: 0 to 100 (‑100 dB to 0 dB)
X11!
= Analog input gain: -18 to +24 dB
X11@
= Clip status:
0 = Off (no clipping)
1 = On (clipping)
X12)
= Text – up to 64 characters
X12!
= SNMP Trap target number (1 to 3)
X12@
= SNMP Trap version for target (2 or 3)
NOTE: Unless otherwise indicated, commands are not case‑sensitive.