Fagor AD-505 - System Connections

22/07/2019
14
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
6.4. OTHER DATA
MOD.
/ h
Cycle (s) Pump Tank Boiler kg NS
CO-500
500mm
x
500mm
30
120/180
2.5
L / cycle
20 L
7 L
70 kg
< 65 dB
CO-501
40 90/120/180
CO-502
COP-504
2.4
L / cycle
AD-505 60
60/90/120/Gla
ss
14 L 71 kg
7. INSTALLATION OF THE MACHINE
7.1. LOCATION
An extractor hood should be installed to prevent the build-up of steam in the premises.
Place the equipment in a sufficiently ventilated room, in accordance with the current regulations, to prevent the
formation of unacceptable concentrations of harmful substances in the installation site.
Inspect final location of the equipment prior to installation to prevent damage during use.
Unless otherwise indicated, the parts that have been protected by the manufacturer must not be manipulated by
the installer.
• The placement, installation, repairs and/or modifications must always be carried out by an Authorised Service
Technician in accordance with the manufacturer's instructions and the applicable regulations.
• Do not change the position of or handle the machine components, as this may affect the operating safety.
• The appliance must be correctly levelled and the electrical cables, gas pipes, water and drainage hoses must
not be trapped or contain kinks.
• The appliance has been designed to operate at ambient temperatures ranging from 5 ⁰C to 40 ⁰C and must not
be used at temperatures below 5 ºC.
• The appliance or any of its parts must never be used as a support and objects must not be placed on top.
• Do not install the appliance in places exposed to jets of water.
• This appliance must be installed in accordance with the current applicable legislation. It may only be installed
on premises which are correctly ventilated in order to prevent the formation of unacceptable concentrations of
substances harmful to human health.
• You must check that there are no gas leaks. NEVER use a flame to check for leaks.
F
Detergent inlet
G
Equipotential connection