Fagor AD-505 - Thermo-Stop

22/07/2019
45
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
The default setting of the appliance is English. Therefore go to LANGUAGE (LANG) to change the language. To
go to the User Menu in the LANGUAGE (LANG) option, press START. Select the required language by pressing
MENU to select and START to confirm.
To configure the date and the time, go to DATE/TIME. With the format DAY/MONTH/YEAR HOUR/MINUTE
(D
1
D
2
/M
1
M
2
/A
1
A
2
H
1
H
2
/m
1
m
2
) use the MENU and START buttons to change the digits one by one (the active
digit flashes).
When the machine is installed, the following parameters should be configured if necessary:
SOFT appliance
 The default setting of the SOFT models is highlighted, but this value must be configured
depending on the water hardness measurement.
WATER HARDNESS
0-9 ºfH (NO-SOFT) / 9-18 ºfH / 18-27 ºfH / 27-36 ºfH / 36-45 ºfH / >45 ºfH
It is also possible to modify the following parameters at the request of the user:
CONFIG. SYSTEM
TEMP. RANGE.
WASH
P1:60 ºC (140 ºF) / P2:60 ºC (140 ºF)/ P3:60 ºC (140 ºF)/ PG:60 ºC (149 ºF)  [55-71 ºC] (131 ÷ 159 ºF)
RINSE
P1:82 ºC (180 ºF) / P2:82 ºC (180 ºF) / P3:82 ºC (180 ºF) / PG:65 ºC (149 ºF)  [65-85 ºC] (149 ÷ 185 ºF)
CYCLE TIME
WASH
TOP-LOADING
P1:39s[35s-60s] / P2:59s[55s-80s] / P3:104s[100s-500s] / PG:74s[70s-95s]
RINSE
P1:11s / P2:11s / P3:11s / PG:11s  [10s-14s]
DRAINAGE CYCLES
100 (50-400)
9.6.4. THERMO-STOP
When the thermo-stop is activated, the wash cycle is extended, if necessary, until the boiler reaches a rinse
temperature which will guarantee correct hygienisation in accordance with health regulations.
CONFIG. SYSTEM
HEATING TYPE
SIMULTANEOUS / ALTERNATE
TEMP SCALE
ºC / ºF