22/07/2019
32
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
For correct drainage with the drainage pump, the height of the drain must not be more than 500 mm
above the level of the machine drainage.
The dishwashers have two types of drainage; gravity drainage or using a drainage pump.
Drainage by gravity
If the drain is lower than the appliance drainage pipe, just remove the relief valve to allow the water to flow freely
under gravity.
The machine should be switched off first.
Drainage using the drainage pump
The pump may be ordered prior to the purchase of the machine or installed subsequently. ADVANCE models are
fitted with a drainage pump as standard.
If the appliance has a drainage pump and the drain is higher than the machine drainage pipe, the drainage method
is as follows:
CONCEPT and CONCEPT PLUS models
• Remove the overflow valve.
• In the models with Cycle SELECTOR switch , turn the switch to DRAIN, then open and close the hood.
• If the machine does NOT have a Cycle SELECTOR switch, just press and hold the P1 button for 3 seconds
with the hood open, and the drainage cycle will start immediately. The Led L1 lights up while the cycle is running.
• On completion of the drainage, replace the relief valve and switch off the machine.
ADVANCE model
ADVANCE models are fitted with a drainage pump as standard and there are three ways of draining the tub:
Automatic drainage
Five minutes after switching off the machine, the wash tub is automatically drained, unless a Manual Drain or Self-
cleaning Cycle are run first.
Manual drainage
To drain the machine immediately without waiting 5 minutes, when the machine is switched off go to the User
Menu and select YES in the DRAIN option. Keep the door closed.
9.3.5. SWITCHING OFF THE MACHINE
• In the models with Cycle SELECTOR switch, turn the switch to 0.
• If the machine does not have a Cycle SELECTOR switch just press and hold the ON/OFF button for 2
seconds.
In the ADVANCE models, 5 minutes after switching off the machine, an Automatic Drainage of the wash tub is run,
unless a Manual Drainage or a Self-cleaning Cycle are run first.
If the machine is a SOFT model, it is possible that 15 minutes after switching it off, the appliance will run a
regeneration lasting 15 minutes, during which the message REGENERATION is displayed.
To Next Page
Loading...
