22/07/2019
31
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
Before switching on the machine:
Check that the wash/rinsing arms are correctly positioned and
fastened and rotate correctly.
The corresponding filters must be clean and in place.
The overflow should be mounted in place. Press until it is firmly
inserted.
Check and maintain the levels of detergent and rinse aid in the
containers to ensure they last throughout the working day.
Make sure that the weight and filter are correctly fitted on the
tubes and that the tubes are correctly immersed in the correct
containers.
Open the water mains tap and check that there is water.
Switch on the mains power switch.
Close the door of the machine.
To switch on the machine, turn the cycle selector switch SELECT to any wash cycle P1, P2, P3
, and the Led ON
light will come on.
If the machine does not have a cycle selector switch, just press the ON/OFF button for 2 seconds, and the Led
ON light will come on.
In the ADVANCE model, in addition to the Led ON light, the DISPLAY light will also come on, indicating that the
machine is filling. The START button will light up in red.
ATTENTION: DO NOT INSERT HANDS AND/OR TOUCH THE INTERNAL PARTS OF THE TANK WHILE
THE MACHINE IS OPERATING AND WAIT 10 MINUTES AFTER THE WASH TANK HAS DRAINED.
9.3.3. FILLING AND HEATING
The hood must be fully closed for the machine to start filling.
When the machine is switched on, the boiler and the wash tank are filled with water which is heated to the
correct wash and rinse temperatures.
The CONCEPT PLUS and the ADVANCE model are fitted with a thermostatic filling system, so that the filling
process is a cyclical repetition of the following sequence: fill boiler, preheat and partially fill wash tank. This
system allows the machine to be filled more quickly as it uses the boiler's increased power to heat the water.
The filling and heating process will last several minutes, the time depending on the water intake temperature
and the power of the machine; the machine is designed to start cleaning the dishes when the MACHINE READY
pilot light or the thermometers indicate temperatures between 55 ⁰C - 65 ⁰C / 131 ºF - 149 ⁰F in the wash tank
TANK TEMPERATURE and between 80 ºC - 85 ºC / 176 ºF - 185⁰F in the rinse boiler BOILER TEMPERATURE.
In the ADVANCE model, the START button changes from red to green when the filling process has finished and
the correct wash and rinse temperatures have been reached.
During the first heating of the day, the boiler may reach higher temperatures than normal due to the
heating inertia as the boiler water is cold. This is normal.
9.3.4. DRAINAGE
At the end of the working day or when it is necessary to change the wash water because it is too dirty, the wash
tank should be drained.
Wait at least 10 minutes after switching off the machine before cleaning the inside of the appliance.
To Next Page
Loading...
